Electronics Forum | Wed Sep 08 14:31:48 EDT 1999 | John Thorup
| | Hello: | | We are using a Heller 1500S reflow oven to solder surface mount parts. Just within the last two weeks, the larger I.C.'s are moving while going through the oven. The parts are checked for placement before putting into the oven.
Electronics Forum | Thu Sep 15 21:25:43 EDT 2011 | darby
G'day folks - haven't been around for some time but still soldering on. Question for y'all. One of my design engineers has shown me a Creative PCI audio card with a TQFP48 attached. 0.4mm pitch. Let's say the pin width is 0.2mm and the pad design ha
Electronics Forum | Thu Sep 15 21:36:52 EDT 2011 | darby
I also posted this in the design section... G'day folks - haven't been around for some time but still soldering on. Question for y'all. One of my design engineers has shown me a Creative PCI audio card with a TQFP48 attached. 0.4mm pitch. Let's say
Electronics Forum | Fri Apr 13 22:56:02 EDT 2001 | gdstanton
I've been chipping away on a solder bridging and poor fillet wetting problem for a few weeks now (new to the company) and I found two issues. First, after a review of stencil inventory, I found apertures to be oversized when compared to suggested di
Electronics Forum | Tue Nov 01 12:36:19 EST 2005 | moonshine
What's your pad geometry/sizes relative to lead width/length? Revisit this and my free website: http://www.moonmanondarkside.com and see some examples and download some free documents. MoonMan
Electronics Forum | Thu Apr 09 09:25:04 EDT 1998 | Terry Burnette
| I am in urgent need of a pcb land patten (footprint)for this device. I have the component data sheet with with package dimensions from Motorola, but they do not include the recommended land pattern. I requested a patten over a week ago, but have
Electronics Forum | Wed Dec 06 16:17:31 EST 2006 | Mario Scalzo, CSMTPE
Normally, we try to limit the over print of the paste to the width of the pad on both sides. If you are using 500um pad, then I wouldn't try over a 1500um aperture. Mario Scalzo, CSMTPE, Dartmouth 6 Sigma Green Belt Technical Support Engineer - Ind
Electronics Forum | Thu Feb 04 06:50:35 EST 1999 | Greg Flynn
What allowances are people using out there for components off-pad, we currently use 50% of lead width without breaking trace/component clearances but we have a customer demanding 25% allowance ?
Electronics Forum | Thu Feb 04 09:09:11 EST 1999 | Peet
| What allowances are people using out there for components off-pad, we currently use 50% of lead width without breaking trace/component clearances but we have a customer demanding 25% allowance ? | We use 50% for civile application, and 25% for mil
Electronics Forum | Tue Sep 18 18:36:59 EDT 2001 | mparker
... and don't forget proper stencil alignment. Invariably I find most bridging problems for fine pitch parts, etc. is caused by lousy alignment. The alignment must be verified under magnification, using the naked eye is not good enough. Use at least
